ADR bearing designation: F638/4
ADR bearing designation: F638/4
This designation is only defining the size and shape of the ball bearing. Materials and performances have to be detailed during study and quotation.
Bearing Dimension
| d | 4 mm | D | 9 mm | |
|---|---|---|---|---|
| d1 | 5.2 mm | D1 | 7.48 mm | |
| Dc | 10.3 mm | C1 | 1 mm | |
| B* | 4 mm | r | 0.15 mm | |
Bearing available with protective flange | ||||
|
* For protected bearing (ZZ, FF, -2RS) |
||||
Speed Limit
| Lubricant & Bearing Type 1 | |
|---|---|
| Ball bearing with ribbon cage + grease | 60,000 rpm |
| Lubricant & Bearing Type 2 | |
|---|---|
| Ball bearing with ribbon cage + oil | 90,000 rpm |
Basic Load Rating of Bearing
| Static radial capacity [Co] | 192 N |
|---|---|
| Static axial capacity [Ca] | 152 N |
| Dynamic radial capacity (X105CrMo17) [C] | 438 N |
| Dynamic radial capacity (100Cr6) [C] | 547 N |
| To improve Capacity and Life time Contact us | |
Bearing Version
| Serie | Rigid bearing - Metric serie, with flanged outer ring |
|---|---|
| Conception | Deep groove ball bearing |
| Cage | With stainless steel ribbon cage |
| For Bearing Protected with Shields or Seals Contact us | |
Tolerance, Internal Clearance and Calibration
| Tolerance class selected usually | Class “T4” for Rigid ball bearing |
|---|---|
| Class “TA4” for Thin Section ball bearing | |
| For Others Tolerances Refer to catalogue Page 32 to 43 | |
Assembling Configuration
ADR proposes different bearings pair configuration in standard, for example:
- DO for Duplex ball bearings in Back-to-Back configuration
- DX for Duplex ball bearings in Face-to-Face configuration
|
To define assembling configuration and preload value: |
Mean Mass
| Ball bearing mass | 1.13 g |
|---|
Additional Informations
Recommended lubricant operating temperature:
Open ball bearing: Oil, ISOFLEX PDP38 – Minimum -65°C and +100°C maximum
Protected ball bearing: Grease, NYCOGREASE GN10 – Minimum -73°C and +121°C maximum
In standard Stainless steel ring and cage, maximum temperature to 150°C
Phenolic resin cage, maximum temperature to 120°C
PTFE separators balls, maximum temperature to 150°C
For further information on the F638/4 designation
Data are not contractually binding. ADR disclaims any responsibility for printing errors in this data sheet.